241.805.012
28
Date: 2017-10-24
Changing wire
If the wire has any damaged, the winch must not be used until the wire has been replaced
(See section “Parts” on page 23). This can be done following the instructions below, or by
Wahlberg. Please contact Wahlberg Motion Design for information regarding approved spare
parts and questions for the procedure.
Procedure for changing the wire:
1.
Roll off the wire:
a.
Set the winch to MODE 8 (Manual roll down)
b.
Pull down in the wire to de-activate the slack detection.
c.
Continue pulling until all the wire has been rolled off the winch
d.
Cut off the old wire using a steel rope cutter
2.
Disconnect the power.
3.
Remove the 6× M3 hexagonal socket screws, on each middle plates on the winch.
4.
Take off the two loose middle plates, to access the wire mount.
5.
Remove the end frame and plate by removing the four M4 hexagonal socket screws.
6.
Remove the four hexagonal spacers and the two bolts holding the TRAFO-plate.
7.
Remove the two bolts and nuts holding the mounting plate and the TRAFO-plate
together.
Summary of Contents for 241
