241.805.012
19
Date: 2017-10-24
4
Set soft TOP limit
This channel controls the maximum top travelling height of the winch. When the
winch has been reset and the soft TOP limit thereby has been declared, it is
possible, by adjusting this channel, to change how high the winch may run in
proportion to the soft TOP limit. So the top travelling height for the winch is
changed.
0% declares the maximal top travelling height, which means it runs all the way
up to the soft TOP limit.
100% declares the minimal top travelling, which means it is as far from the soft
TOP limit as possible.
By adjusting this channel the positioning run from 0 - 100% will be within this
new parameter. The top travelling height can be changed as needed, without
resetting the winch’s soft TOP limit.
5
Set soft BOTTOM
limit
The channel controls the soft BOTTOM limit of the winch. When the winch has
been reset and the soft TOP limit thereby has been declared, it is possible, by
adjusting this channel, to change how low the winch may run in proportion to
the soft BOTTOM limit. So the soft BOTTOM limit for the winch is changed.
0% declares the maximal bottom travelling height, which means it, runs all the
way down to the soft BOTTOM limit.
100% declares the minimal bottom travelling, which means it is as far from the
soft BOTTOM limit as possible.
By adjusting this channel the positioning run from 0 - 100% will be within this
new parameter. The bottom travelling height can be changed as needed,
without resetting the winch soft TOP limit.
6
Find soft TOP
limit, moving UP
The channel is used to manually finding the soft TOP limit. The channel controls
the speed from 0-100%.
The winch starts to run up when channel 6 is set above 0%. When the winch
reaches the wanted soft TOP limit, the speed must be set to 0 %, so that the
motor stops.
The soft TOP limit of the winch is then set to the position the winch stopped in.
The soft TOP limit should always be near by the motor-house. See more details
in the passage controlling the soft TOP and BOTTOM limits.
Attention! The positioning run in MODE 2 works only, when the winch has
been reset.
7
Moving down
The winch starts to run down when the speed is set above 0 %. This can be used
to manually move the winch down without using positioning.
This does not change the soft TOP limit.
Table 3 - Overview of DMX addresses
Summary of Contents for 241
