241.805.012
25
Date: 2017-10-24
On-site service
On-site service and maintenance can be provided by the Wahlberg Motion Design,
giving owners access to Wahlberg Motion Design’s expertise and product knowledge in
a partnership that will ensure the highest level of performance throughout the
product’s lifetime. Please contact Wahlberg Motion Design for details.
Life of the wire
It is Wahlberg policy to apply the strictest possible calibration procedures and use the
best quality materials available to ensure optimum performance and the longest
possible component lifetimes. However, wires are subject to wear and tear over the
life of the product, resulting in special attention to the state of the wire. The extent
of wear and tear depends heavily on operating conditions and environment, so it is
impossible to specify precisely whether and to what extent the wire performance will
be affected.
The expected lifetime of the wire depends on the load and travel length as well as
duty cycle (refer to Table 5).
Table 5 - Expected wire life time at 0° angle
Load
Max. expected number of cycles (up and down)
2.5 kg 80,000
5.0 kg 20,000
10 kg
15,000
The wire should be inspected long before these numbers are reached and checked for
damages, and replaced if necessary
Figure 1: Illustration of the Winch 10 mounted in different angles
Summary of Contents for 241
