Wahlberg 241, User Manual

Page: 13 / 40

241.805.012 13 Date: 2017-10-24
AC power
Warning! Read “Safety Information” on page 2 before connecting the winch to AC
mains power.
Warning! For protection from electric shock, the winch must be grounded
(earthed). The power distribution circuit must be equipped with a fuse or circuit
breaker and ground-fault (earth-fault) protection.
Warning! Socket outlets or external power switches used to supply the winch with
power must be located near the winch and easily accessible so that the winch can
easily be disconnected from power.
Warning! Check that the voltage range specified on the winch’s serial number label
matches the local AC mains power voltage before applying power to the winch. Do
not apply AC mains power to the winch at any other voltage than that specified on
the winch’s serial number label.
Power cables and power plug
The Winch 10 requires a power input cable with a Neutrik powerCON TRUE1 NAC3FX-W
cable connector for AC mains power input. The cable must meet the requirements
listed under “Protection from electric shock” on page 2.
Wahlberg Motion Design can supply the PowerCON input connector without a cable.
If you install a power plug on the power cable, install a grounding-type (earthed) plug
that is rated 20 A. Follow the plug manufacturer’s instructions. Table 1 shows standard
wire color-coding schemes and some possible pin identification schemes; if pins are not
clearly identified, or if you have any doubts about proper installation, consult a
qualified electrician.
Table 1 - Colour guide
Wire Colour Conductor Symbol Screw (US)
Brown Live L Yellow or brass
Blue Neutral N Silver
Yellow/green Ground (earth)
or
Green
Installing a power input connector on a power cable
To install a Neutrik powerCON TRUE1 NAC3FX-W input connector on a power
Cable, follow the original Neutrik instructions in Appendix 2.