241.805.012
40
Date: 2017-10-24
How to get started
1.
Place / Rig the winch in something high with a minimum of 2-3 clearance meter below.
2.
Put on counterweight on the winch hock, minimum 0.4 kg (0.88 lb).
3.
Set the DMX start address to 001, and the MODE to 2.
4.
Apply DMX from a lighting desk, preferably with manual faders.
5.
Make sure that the 7 channels are patched from DMX channel 1 to 7.
6.
Pull all channels on to 0%
7.
Apply power to the winch.
DMX lamp should be lit, and the mode lamp should be flashing.
8.
Pull channel 6 to 20 % - the winch starts pulling the wire.
9.
When the wire is at the hard TOP limit (pulled into the winch), stop the winch (set channel 6 to
0%)
NOW the winch has found its TOP position and is ready to drive with position control.
10.
Pull channel 1 (position) to 95 %
11.
Pull channel 3 (speed) to 20%
Now the winch start to move down, with 20% speed, to the 95% up-position.
12.
Pull channel 1 (position) to 80%
Now the winch starts to move down, with 20% speed, to the 80% up-position.
13.
Pull channel 1 (position) to 90 %
14.
Pull channel 3 (speed) to 50%
The Winch starts to move UP again, with 50% speed, and stops 1 meter before the top
.
Winch 10 - Cheat Sheet
MODE Functions
DMX
channels
Function
0
Neutral function – motor stops
1
Position rough (Hi of a 16 bit DMX channel)
1
Positioning with auto TOP reset
2
Position fine (Lo of a 16 bit DMX channel)
2
Positioning with manual TOP reset
3
Set the maximum speed
3,4,5,6 Stops the motor unless specified otherwise
4
Set the soft TOP limit
7
Manual run up (DMX address = speed)
5
Set the soft BOTTOM limit
8
Manual run down (DMX address = speed)
6
Find hard TOP limit, moving up (reset speed)
9
Used for re-calibrating overload see page 21 7
Moving down
Inspection
points
Intact wire
Broken wire
Before each use
−
Check that the winch is safely and correctly installed/mounted.
−
Inspect the entire length of the wire rope for bends, damage
and wear, cut cords, corrosion and abuse.
−
Inspect the wire ferrule crimp and thimble for damage, wear,
corrosion or abuse.
−
Secure that the load is safely attached and weighs maximum 10
kg (22.0 lb).
−
Check all limit switches
−
Check the slack detection device
Warning! Do not use the winch if any damage or error is found!
Summary of Contents for 241
