241.805.012
31
Date: 2017-10-24
20.
Ensure that the ‘top stop’ and slack detection spring is correctly mounted.
21.
Hereafter the wire must be rolled on – See the section below: Applying the wire.
22.
When the wire end is ~30 cm away from the ‘top stop’, stop the wire roll up.
Place the top bead (wire stop) on the wire and make an eye using thimble and
ferrule (approved by Wahlberg). Ensure to use appropriate swaging or crimping
tools.
Attention! The wire stop is essential for the function of the winch. Forgetting
the spring will damage the winch!
23.
Roll up the last bit of the wire.
Summary of Contents for 241
