241.805.012
30
Date: 2017-10-24
15.
Mount the wire-wheel back on the winch. You might need to take out the slack
detection to make it fit in.
16.
Ensure that the spacing washer for slack detection is installed.
17.
Assembly the winch by placing the TRAFO-plate on top of the wire-wheel. Ensure
that the ‘top stop’ and slack detection is correctly mounted.
18.
Tighten the bolts and nuts for the mounting bracket. Check that you use the right
bolts, by ensuring that the bolt goes through the nut and self-locks.
19.
Mount the four hexagonal spacers and the two bolts holding the TRAFO-plate.
Summary of Contents for 241
