241.805.012
16
Date: 2017-10-24
Emergency stop
There is no dedicated emergency stop for this winch. The winch is controlled from a
lightning desk, where it should always be set up with a button that sets the speed of
the winch in operation to 0%.
Normally lighting desks have a “blackout” button that sets all signals to 0% and this
will also cause the winch to stop.
MODE setting
The MODE setting allows you to operate the winch in different ways. Each MODE
setting has a given function. Each mode gives an opportunity for different operational
settings of the winch. The MODE is selected using the MODE selector on the Winch.
The winch needs to be reset, before the positioning MODE is possible. The winch can
be reset manually or automatically. The winch must be reset each time its power
supply has been disconnected.
Read the passage about controlling the soft TOP- and BOTTOM limits, to explore and
setup the winch for your own particular needs.
Warning! Only operate the winch when there is a clear view to the winch and area
beneath it.
Warning! Before running the winch, ensure that the area beneath the winch is
cleared to avoid risk of injury.
Warning! When resetting the winch in MODE 2, it is important to decrease the
speed, as the snap hook is closing in on the motor-house, otherwise the wire and
winch can be damaged.
Warning! MODE 7 and MODE 8 is only for service and tests!
Summary of Contents for 241
