92 Mounting
WAGO-I/O-SYSTEM 750 XTR
750-8212/040-010 PFC200 G2 2ETH M12 RS XTR
Manual
Version 1.0.0, valid from FW version 03.01.07(13)
Mixed operation
Mixed operation (standard/XTR modules) within a node is possible when groups
of modules are electrically isolated on the field side (i.e., electrically isolated
power supply).
5.6
Inserting Devices
Do not work when devices are energized!
High voltage can cause electric shock or burns.
Switch off all power to the device prior to performing any installation, repair or
maintenance work.
5.6.1
Inserting the Controller
1.
When replacing the controller for an already available controller, position
the new controller so that the tongue and groove joints to the subsequent
I/O module are engaged.
2.
Snap the controller onto the carrier rail.
3.
Use a screwdriver blade to turn both locking discs until the noses of the
locking discs engage behind the carrier rail (see the following figure). This
prevents the controller from canting on the carrier rail.
With the controller snapped in place, the electrical connections for the data
contacts and power contacts (if any) to the possible subsequent I/O module are
established.
Figure 23: Locking Discs of Controller
