WAGO-I/O-SYSTEM 750 XTR
Service 363
750-8212/040-010 PFC200 G2 2ETH M12 RS XTR
Manual
Version 1.0.0, valid from FW version 03.01.07(13)
13
Service
13.1 Inserting and Removing the Memory Card
</dg_
13.1.1 Inserting the Memory Card
1.
Use an actuating tool or a screwdriver to open the transparent cover flap by
flipping it upwards. The point where to position the tool is marked with an
arrow.
2.
Hold the memory card so that the contacts are visible on the right and the
diagonal edge is at the top, as depicted in the figure below.
3.
Insert the memory card in this position into the slot provided for it.
4.
Push the memory card all the way in. When you let go, the memory card
will move back a little and then snap in place (push-push mechanism).
5.
Close the cover flap by flipping it down and pushing it in until it snaps into
place.
6.
You can seal the closed flap through the hole in the enclosure next to the
flap.
Figure 122: Inserting the Memory Card
</dg_
