Wachs WS-8460, User Manual

Page: 29 / 96

Chapter 3, Operating Instructions: Adjusting Clamp Arms for the Pipe Size
E.H. Wachs Part No. 10-010-MAN, Rev. 1-0310 25
Figure 3-8. The photo shows the size stamps on the
WS-8460 model. The pin is in the 78-84” position.
Positioning the Clamp Arms
Do not attempt to change the
clamp arm positions while the
saw is in a vertical position.
The clamp arms may fall
when the pins are removed,
resulting in personal injury
and equipment damage.
Make sure the saw is sitting horizontally on a level surface
before you adjust the clamp arms.
1.
Remove the spring clips from both pin ends of the
forked pin, then pull the forked pin out of the frame.
78 72” to 78” (1829-1981 mm)
84 78” to 84” (1981-2134 mm)
Table 5: Pipe Size Ranges for Clamping
Arm Positions—WS-8460
Size Stamp Pipe Diameter Range
WARNING