Diamond Wire Saw User’s Manual
50
Part No. 10-010-MAN, Rev. 1-0310
E.H. Wachs
Figure 4-20. The photo shows the locations of the ten-
sion control system components on the WS5230 saw
model. The assemblies are in the same location on all
models of the diamond wire saw.
1.
Position the saw so that the bow is face down (oppo-
site the way shown in Figure 4-20). Use blocks under-
neath it to avoid damaging the grease fittings.
The full assembly drawings
with parts lists are included in
Chapter 5.
2.
Remove the cylinder from the spring assembly by
removing ¼-28 SHCS and 1-1/4" nut. Temporarily put
the fasteners back on the cylinder. Note: SHCS is Item
14 and Nut is Item 9 on drawing 10-010-00-435,
shown in Figure 4-21.
Figure 4-21. The drawing illustrates the components
of the spring assembly. Item 2 is the spring assembly
cylinder.
Spring tension
assembly
(10-010-00-435)
Tension control
mechanism assembly
(10-010-00-418)
NOTE
cross-section
Summary of Contents for WS-8460
Page 2: ...Diamond Wire Saw User s Manual Part No 10 010 MAN Rev 1 0310 E H Wachs...
Page 18: ...Diamond Wire Saw User s Manual 14 Part No 10 010 MAN Rev 1 0310 E H Wachs A B C...
Page 22: ...Diamond Wire Saw User s Manual 18 Part No 10 010 MAN Rev 1 0310 E H Wachs...
Page 40: ...Diamond Wire Saw User s Manual 36 Part No 10 010 MAN Rev 1 0310 E H Wachs...
