Wachs WS-8460, User Manual

Page: 52 / 96

Diamond Wire Saw User’s Manual
48 Part No. 10-010-MAN, Rev. 1-0310 E.H. Wachs
4.
Remove the hub bolt and spacer bolt from the wheel
assembly, as shown in Figure 4-18. Be careful not to
lose the spacer.
5.
Pull the top plate off the wheel.
6.
Pull the wheel up off the motor shaft. Note the side of
the wheel that mounts onto the motor; the wheel is not
reversible.
7.
Disassemble the wheel and replace the liner as
described in the previous section, “Tension and Idler
Wheels”.
8.
Replace the wheel on the motor shaft, making sure the
correct side is toward the motor.
9.
Replace the top plate. Insert the spacer bolt through
the spacer and snug it down.
10.
Replace the hub bolt and snug it.
11.
Replace the tension rod mounting bolt through the
plates and tension rod end. Put the nut on the end of
the bolt and tighten it securely.
12.
Tighten the spacer bolt and hub bolt securely.
13.
Slide the wheel and motor assembly plates into place
in the saw bow and line up the pivot pin holes.
14.
Set the stop collars in place between the plates. Insert
the pivot pin through the top plate, the stop collars,
and the bottom plate.
15.
Holding the pivot pin in place, position the stop col-
lars against the mounting plates and tighten the set
screws.