Wachs WS-8460, User Manual

Page: 14 / 96

Diamond Wire Saw User’s Manual
10 Part No. 10-010-MAN, Rev. 1-0310 E.H. Wachs
Figure 1-9. The photo shows the controls on the top-
side control unit. (The fourth circuit, to the far right, is
not used with the subsea wire saw.)
Rigging the Machine
A rigging instruction label is attached to the top of the
machine frame on WS-164 through WS-5230 models. See
the end of this section for information on rigging the WS-
8460 model.
Figure 1-10. The rigging label is on top of the frame.
Clamp pressure gauges
Clamp
direction
Cutter
speed
Cutter pressure gauge
Feed speed Feed pressure gauge
Feed
direction
Clamping flow levers (engage
both at once—shown closed
under pressure)
Feed flow lever
(shown open)
Cutter flow lever
(shown open)