Wachs WS-8460, User Manual

Page: 50 / 96

Diamond Wire Saw User’s Manual
46 Part No. 10-010-MAN, Rev. 1-0310 E.H. Wachs
9.
Fasten the side plate with the 12 screws. Snug each
screw, then tighten them in a criss-cross pattern to
secure the wheel evenly.
Figure 4-16. Replace the screws in the side plate.
10.
Replace the wheel into its mounting fixture. Put the
bolt through the top of the fixture, and install the nut
on the bottom. Tighten the nut securely.
Drive Wheel
Remove the cutting wire before taking off any of the
wheels.
To replace the drive wheel liner, you must first remove the
wheel and motor assembly from the saw bow using the fol-
lowing procedure.
1.
Hold or support the drive wheel and hydraulic motor
assembly, so that it does not fall when you remove the
fasteners holding it to the saw bow.
2.
Loosen the set screws in the stop collars on the pivot
pin and remove the pin from the frame. Be careful not
to lose the stop collars.