Diamond Wire Saw User’s Manual
20
Part No. 10-010-MAN, Rev. 1-0310
E.H. Wachs
2.
Tighten the drive wheel tensioning knob, as shown in
Figure 3-2, until you can see the line on the spring-
loaded driver wheel, Figure 3-3.
Figure 3-2. Turn the tension knob on the drive wheel
fixture to increase the tension on the wire. (Depending
on the exact length of the wire, about 3-4” of the screw
will be visible when the tension is set correctly.)
Figure 3-3. When the wire is properly tensioned, the
start lines will be lined up together.
3.
You should be able to deflect the wire fairly easily by
pushing it up between the idler wheels. Push it in far
enough to compress the tension spring, and make sure
the actuator rod extends into the slot in the shaft.
Summary of Contents for WS-8460
Page 2: ...Diamond Wire Saw User s Manual Part No 10 010 MAN Rev 1 0310 E H Wachs...
Page 18: ...Diamond Wire Saw User s Manual 14 Part No 10 010 MAN Rev 1 0310 E H Wachs A B C...
Page 22: ...Diamond Wire Saw User s Manual 18 Part No 10 010 MAN Rev 1 0310 E H Wachs...
Page 40: ...Diamond Wire Saw User s Manual 36 Part No 10 010 MAN Rev 1 0310 E H Wachs...