VTI Instruments EX1000A, User Manual

Page: 12 / 320

VTI Instruments Corp.
12 EX10xxA Introduction
G
ENERAL
S
AFETY
I
NSTRUCTIONS
Review the following safety precautions to avoid bodily injury and/or damage to the product. These
precautions must be observed during all phases of operation or service of this product. Failure to
comply with these precautions, or with specific warnings elsewhere in this manual, violates safety
standards of design, manufacture, and intended use of the product. Note that this product contains
no user serviceable parts or spare parts.
Service should only be performed by qualified personnel. Disconnect all power before servicing.
T
ERMS AND
S
YMBOLS
These terms may appear in this manual:
WARNING
Indicates that a procedure or condition may cause bodily injury or death.
CAUTION Indicates that a procedure or condition could possibly cause damage to equipment
or loss of data.
These symbols may appear on the product:
ATTENTION - Important safety instructions
Frame or chassis ground
Indicates that the product was manufactured after August 13, 2005. This mark is
placed in accordance with
EN 50419, Marking of electrical and electronic
equipment in accordance with Article 11(2) of Directive 2002/96/EC (WEEE) .
End-of-life product can be returned to VTI by obtaining an RMA number. Fees
for take-back and recycling will apply if not prohibited by national law.
W
ARNINGS
Follow these precautions to avoid injury or damage to the product:
Use Proper Power Cord
The power cable provided with this instrument meets the required
regulatory and statutory safety standards as indicated by this
product’s declaration of conformity. VTI recommends that the power
cord provided be used with the instrument that it is provided with. If
a different power cord is must to be used, however, it is the
responsibility of the user to select a power cord that meets any and
all regulatory and statutory requirements for their industry and
country.
Do not use the power cord supplied with this instrument with any
other equipment.
Use Proper Power Source
To avoid electrical overload, electric shock, or fire hazard, do not use
a power source that applies other than the specified voltage.
The mains outlet that is used to power the equipment must be within
3 meters of the device and shall be easily accessible.