Installation steps overview
2.9
WG500
TM
4. Mounting the camera
1.
Unpack the camera and the camera mounting hardware. Refer to the following
illustration as you mount the camera:
2.
Locate the two black mounting brackets inside the camera mounting bag and
separate them from each other. (One mounting bracket is labeled
Camera
. The
Monitor bracket is not labeled.)
3.
Attach the Camera mounting bracket to the bottom of the camera by inserting
the flathead screw through the large countersunk hole. Orient the bracket so
that the curved side is toward the front and the word
Camera
is visible from the
bottom of the mounting bracket.
4.
Make sure that the mounting area on top of the monitor is free from dust, oils,
or any other material or chemicals which might prevent proper adhesion.
5.
Orient the remaining bracket (Monitor) so that the studs face up. Remove the
paper liner from the foam adhesive gasket on the bottom of the monitor
bracket. Position the bracket in the center of the top of the monitor with thumb
nut studs towards back of monitor (see illustration), and press down firmly
over the entire surface to set the adhesive.
Sony D30/31 PTZ
Thumb nut
Camera bracket
Monitor bracket
Mounting screw
V-slot
Front stud
(underside)
Summary of Contents for WG500
