VTAC HSD USER MANUAL: SECTION 7
VIRGINIA PANEL CORPORATION
1/9/19
7-4
For the most current information available, visit vpc.com
VTAC HSD RIGHT ANGLE INSERT PCB INSTALLATION INSTRUCTIONS
PART # 610 151 104
TOOLS REQUIRED
VTAC HSD Right Angle Insert Installation Tool, Part # 910 112 132
INSERT INSTALLATION INSTRUCTIONS (CONT’D)
9. The loaded tool is ready to be transferred to the press. The parts should be held fi rmly together so the insert(s) do not come
out of the board. The tool can be pressed with either side up as shown in
Figure J
.
10. Using the press, gentlely push the base and top of tool together until the contacts are seated. Be careful not to over-press.
11. Remove the base the tool as shown in
Figure K
.
12. Remove top half of the tool from the PCB assembly by pushing on the front surface. After the tool has been released, lift it
off the PCB as shown in
Figure L
.
13. Verify that the insert(s) are fully seated against the board along the edge as shown in
Figure M
.
Figure L. Release insert(s).
Figure M. Installing the VTAC HSD Right Angle insert(s).
Figure K. Remove base.
Figure J. Press insert(s) onto board.
PRESS
PRESS
OR
REMOVE BASE
PUSH TO
RELEASE
TOOL
FULLY SEATED
ONCE THE TOOL
IS RELEASED
LIFT OFF INSERTS
