VTAC HSD USER MANUAL: SECTION 7
VIRGINIA PANEL CORPORATION
1/9/19
7-2
For the most current information available, visit vpc.com
VTAC HSD RIGHT ANGLE INSERT PCB INSTALLATION INSTRUCTIONS
PART # 610 151 104
TOOLS REQUIRED
VTAC HSD Right Angle Insert Installation Tool, Part # 910 112 132
INSERT INSTALLATION INSTRUCTIONS
4.
Push each insert to the rear of the tool. Ensure that the rear of each insert is against the rear of the tool as shown in
Figure D
.
Make sure that the insert(s) stay in position until located in the board.
5. If necessary you may push on the tab to help seat each insert(s) as shown in
Figure E
.
Figure D.
Back end of insert(s) should sit fl ush with tool
edge.
FLUSH
PUSH
DETAIL A
Figure E. Installing the VTAC HSD Right Angle Insert(s).
TAB
