VTAC HSD USER MANUAL: SECTION 5
VIRGINIA PANEL CORPORATION
1/9/19
5-1
For the most current information available, visit vpc.com
Figure A. VTAC HSD 90 Series strain relief.
TOOLS REQUIRED
Phillips Head Screwdriver
Wiring Ties
Wire Cutters (to cut wire ties)
ASSEMBLY INSTRUCTIONS
1. Using the Phillips head screwdriver, fasten the strain relief to
the rear (wiring) side of the VTAC HSD 90 Series Module with
the 2-56 screws provided as shown in
Figure A
.
2. Torque screws to 2 in-lbs [0.23 Nm].
3. Secure wires with wiring ties included with strain relief for
restraining wires.
NOTE: Strain relief is required for optimal performance.
VTAC HSD 90 SERIES MODULES ACCESSORIES
●
RECEIVER STRAIN RELIEF ASSEMBLY
PART # 510 109 568
2-56 SCREW
STRAIN RELIEF
