Operation & Maintenance Manual
──
LG956L Wheel Loader
86
z
Lightly set the bucket edge facing down.
z
When driving the machine forward, operate the working
equipment control lever to let the lift arm lower down to the
proper position so that it can pick up a thin layer of the surface
each time when excavating the soil.
z
When driving the machine forward, shift the working equipment control lever backward and
forward slightly to reduce the resistance.
△
!
NOTICE
Keep the two sides of the bucket cutting into the material equally
to prevent only a single side working. Face the loader forward and
never
let an angle exist between the front and rear frame.
(3)
Conveying Operation
The loader must be used without a truck under the following conditions:
z
The ground is too soft and not level, and the truck can not be used.
z
When the transportation distance is within 500 meters, it is not economical to use a truck.
z
The transportation driving speed is determined by the road condition.
z
In order to get good visibility and stability, the bucket should be turned to its upper limit
location(bucket lift-arm touch the upper limited block) and keep the lower pin connection point
of lift-arm at the transportation position (400~500mm above the ground).
(4)
Dumping Operation
z
When dumping material on to trucks or into freight
yards, raise the lift-arm to the position (forward tilt to
the maximum position) where the bucket does not touch
the carriage or material pole. And operate working
equipment control lever to tilt the bucket forward to
dump. Part or all of the material can be dumped by the lever control. Act slowly and gently
during dumping to prevent the bucket from striking the ground.
z
If the material sticks onto the bucket, move the working equipment control lever cyclically to
allow the bucket to tilt forward or backward to shake down the material.
