Vogelsang VX Series, Manual

Page: 174 / 202

Service Manual
Service Manual
Pump Models:
VX Series Q Pumps
Install spacer on the gearbox end
of the shaft, up against the gear
face. Then drive the bearing race
for the bearing over the shaft and
past the cut groove in the shaft
(
Fig. 66 )
Install the circlip into the groove to
hold the bearing race in place
(
Fig. 67 ).
Install the bearing side spacer. If
the drive shaft is being assembled,
note that a race must be installed
above the circlip to accommodate
the lip seal installed later.
Fig. 66
Fig. 67