![background image](http://html.mh-extra.com/html/vlt/automationdrive-fc-300/automationdrive-fc-300_instruction-manual_1042927079.webp)
Warnings and Alarms
Warnings/Alarm Messages
A warning or an alarm is signaled by the relevant LED on the front of the adjustable frequency drive and
indicated by a code on the display.
A warning remains active until its cause is no longer present. Under certain circumstances, operation of
the motor may still be continued. Warning messages may be critical, but are not necessarily so.
In the event of an alarm, the adjustable frequency drive will have tripped. Alarms must be reset to restart
operation once their cause has been rectified. This may be done in three ways:
1.
By using the [RESET] control button on the LCP control panel.
2.
Via a digital input with the “Reset” function.
3.
Via serial communication/optional serial communication bus.
NOTE
After a manual reset using the [RESET] button on the LCP, the [AUTO ON] button must be
pressed to restart the motor.
If an alarm cannot be reset, the reason may be that its cause has not been rectified, or the alarm is trip-
locked (see also table on following page).
Alarms that are trip-locked offer additional protection, meaning that the line supply must be switched off
before the alarm can be reset. Once the cause of the alarm has been rectified and the device has been
switched back on, the FC 300 is no longer blocked and may be reset as described above.
Alarms that are not trip-locked can also be reset using the automatic reset function in parameters 14-20
(Warning: automatic wake-up is possible!)
If a warning and alarm is marked against a code in the table on the following page, this means that either
a warning occurs before an alarm, or that you can specify whether it is a warning or an alarm that is to
be displayed for a given fault.
VLT
®
AutomationDrive FC 300 Instruction Manual
MG.33.A8.22 - VLT
®
is a registered Danfoss trademark.
79