D-302756
67
10.
Press the
button.
The PowerMax10-G2 display will read [
FACTORY DEFIN.
].
11.
Press the
OK
I
button.
The PowerMax10-G2 display reverts to [
FACTORY DEFIN.
].
OK
I
∗
If there are no wireless devices enrolled in the PowerMax10-G2 system, the
PowerMax10-G2 display reads [
NO DEVICES
].
Pressing the
or
buttons at any stage in the procedure will take
you to “
<OK> TO EXIT
” or pressing the
button at the end of the
procedure will take you to the "
WL DEVICES
" menu.
6 CALLING UPLOAD/DOWNLOAD SERVER
Note:
This option is only used during the installation of panels monitored by compatible Monitoring Stations.
This option allows the installer to initiate a call to the upload/download server. The server uploads the PowerMax10-G2
configuration to its data base and can unload predefined parameters to the PowerMax10-G2.
To Perform Server Upload/Download
1.
Make sure the system is disarmed and then press the
button
repeatedly until the PowerMax10-G2 display reads
"
INSTALLER MODE
".
2.
When the PowerMax10-G2 display reads
[
INSTALLER MODE
]
,
press
OK
I
.
OK
I
The screen will now prompt you to enter your installer code.
3.
Enter your Installer Code.
The PowerMax10-G2 display will read [
NEW INSTL CODE
].
CODE
4.
When the PowerMax10-G2 display reads
[
NEW INSTL CODE
]
press the
or
button repeatedly until the PowerMax10-G2 display will read
[
START UL/DL
].
or
5.
When the PowerMax10-G2 display reads [
START UL/DL
], press the
OK
I
button.
OK
I
If the UL/DL server telephone number was already defined (see section 4.6.3.2
"Configuring the Event Types to be Reported"), the PowerMax10-G2 display
will read [
COMMUNICATING
] which is displayed during the dialing process.
If the UL/DL server telephone number was not defined (see section 4.6.3.2
"Configuring the Event Types to be Reported"), the PowerMax10-G2 display
will read [
TEL# NOT DEFINED
] which is displayed for approx. 30 sec. and is
followed by a sad (failure) tune
.
If communication has been established between the PowerMax10-G2 control
panel and the upload/download server, the PowerMax10-G2 display will read
[
DOWNLOADING
] which is displayed during the dialing process.
If communication has failed between the PowerMax10-G2 control panel and
the upload/download server, the PowerMax10-G2 display will read
[
DIAL ATTEMPT FAIL
] which is displayed for approx. 30 sec. and is followed
by a sad (failure) tune
.
After the downloaded/uploaded process has been completed successfully, the
PowerMax10-G2 display will read [
DOWNLOAD OK
] which is displayed for
approx. 30 sec. and is followed by a happy (success) tune.
If communication has been established between the PowerMax10-G2 control
panel and the upload/download server but the downloaded/uploaded process
has failed, the PowerMax10-G2 display will read [
DOWNLOAD FAILED
] which is
displayed for approx. 30 sec. and is followed by a sad (failure) tune
.
Pressing the
or
buttons at any stage in the procedure will take
you to “
<OK> TO EXIT
”.
FACTORY DEFIN.
FACTORY DEFIN.
DIAL ATTEMPT FAIL
DOWNLOADING
DOWNLOAD FAILED
DOWNLOAD OK
TEL# NOT DEFINED
COMMUNICATING
START UL/DL
NEW INSTL CODE
ENTER CODE:
INSTALLER MODE
READY 00:00
