38
D-302756
Note:
Every 2 crossed zones must be of the allowed zone type (Interior, Perimeter, Perimeter follower).
The options are:
cross zone ON
and
cross zone OFF
(default).
Cross zoning is not applicable in Entry/ Exit zones and 24h zones (Fire, Emergency, 24h audible, 24h silent).
To Enable Cross Zoning
1.
Make sure the system is disarmed and then press the
button
repeatedly until the PowerMax10-G2 display reads
"
INSTALLER MODE
".
2.
When the PowerMax10-G2 display reads
[
INSTALLER MODE
]
,
press
OK
I
.
The screen will now prompt you to enter your installer code.
OK
I
3.
Enter your Installer Code.
CODE
4.
Press the
or
button repeatedly and select the [
DEFINE PANEL
]
option.
or
5.
When the PowerMax10-G2 display reads [
DEFINE PANEL
], press
OK
I
The PowerMax10-G2 display will read [
01:ENTRY DELAY 1
].
OK
I
6.
When the PowerMax10-G2 display reads
[
01:ENTRY DELAY 1
],
press
the
or
button repeatedly until the display will read [
14:CROSS
ZONING
].
or
7.
Press
OK
I
and make the selection and then press
OK
I
to confirm.
The PowerMax10-G2 display will revert to [
14:CROSS ZONING
].
OK
I
SELECT OPTION
OK
I
You can now press the
or
button to program any other menu in
"
DEFINE PANEL
"
or
press the
button to take you to "
<OK> TO EXIT
"
.
4.7.2 Configuring Swinger Stop
Here you determine the number of times each zone is allowed to initiate an alarm within a single arming/disarming period
(including tamper & power failure events of detectors, PowerMax10-G2, wireless siren, etc.). If the alarms number from a
specific zone exceeds the programmed number, the control panel automatically bypasses the zone to prevent recurrent
siren noise and nuisance reporting to the Monitoring Station. The zone will be reactivated upon disarming, or 48 hours after
having been bypassed (if the system remains armed).
Available options are:
shut after 1
(default),
shut after 2
(default in USA),
shut after 3
and
no shutdown
.
To Configure Swinger Stop
1.
Make sure the system is disarmed and then press the
button
repeatedly until the PowerMax10-G2 display reads
"
INSTALLER MODE
".
2.
When the PowerMax10-G2 display reads
[
INSTALLER MODE
]
,
press
OK
I
.
The screen will now prompt you to enter your installer code.
OK
I
3.
Enter your Installer Code.
CODE
4.
Press the
or
button repeatedly and select the [
DEFINE PANEL
]
option.
or
5.
When the PowerMax10-G2 display reads [
DEFINE PANEL
], press
OK
I
The PowerMax10-G2 display will read [
01:ENTRY DELAY 1
].
OK
I
6.
When the PowerMax10-G2 display reads
[
01:ENTRY DELAY 1
],
press
the
or
button repeatedly until the display will read [
13:SWINGER
STOP
].
or
14:CROSS ZONING
13:SWINGER STOP
01:ENTRY DELAY 1
ENTER CODE:
INSTALLER MODE
READY 00:00
DEFINE PANEL
14:CROSS ZONING
01:ENTRY DELAY 1
ENTER CODE:
INSTALLER MODE
READY 00:00
DEFINE PANEL
