Vishay G4, Technical Manual, Page: 188 / 200

Technical Manual
8-2
Weight errors
The indication is either temporary or stays on until the cause is cured.
Error
code Explanation
000 No error.
The instrument is in ‘normal state’ and no error is detected.
003 Instrument not in normal state.
Weight is not valid.
004 Overload
Overload means that the weight exceeds the highest allowed limit that is
specified in the set-up parameters ‘Overload check’ and ‘Overload limit’.
005 Over range
Overrange means that the input signal from the transducer exceeds
the operating range.
006 Underload
Underload means that the weight is below the lowest allowed limit that is
specified in the set-up parameters ‘Overload check’ and ‘Overload limit’.
007 Under range
Underrange means that the input signal from the transducer is below
the operation range.
010 Exicitation short-circuit
Either a short-circuit in the excitation circuit or too many transducers
connected. (A fault in a transducer or inside the instrument is also possible.)
Check transducer connections. See chapter 'Installation'.
011 Sense voltage error
The sense voltage is out of range.
Check transducer connections. See chapter 'Installation'.
012 Transducer signal error
The input signal is out of range, for example due to a faulty or missing transducer
connection. (A fault in a transducer or inside the instrument is also possible.)
Check transducer connections. See chapter 'Installation'.
014 Invalid input signal
Invalid input signal is reported while the instrument is waiting for sufficient
conversion data to calculate a valid weight value. This indication is reported
during power-up and after changing the HSWF / WFIN Update Rate settings
since input value might be momentarily unreliable.
020,
191 Too many digits
The actual weight value with the configured number of decimals
is exceeding 6 digits.