VIPA HB130E SM, Manual

Page: 21 / 128

Manual VIPA System 300V
Chapter 2 Assembly and installation guidelines
HB130E - SM - Rev. 07/44 2-7
For the cabling of e.g. the power supply of a CPU, green plugs with
CageClamp technology are deployed.
Here also you may connect wires with a cross-section of 0.08 mm
2
to
2.5 mm
2
. You can use flexible wires without end case as well as stiff wires.
You fix the conductors to the CageClamps like this:
The picture on the left side shows the cabling step by step from top view.
•
For cabling you push the locking vertical to the inside with a suiting
screwdriver and hold the screwdriver in this position.
•
Insert the deisolated wire into the round opening. You may use wires
with a cross-section from 0.08 mm
2
to 2.5 mm
2
.
•
By removing the screwdriver the wire is connected safely with the plug
connector via a spring.
Note!
In opposite to the gray connection clamp from above, the green connection
clamp is realized as plug that can be clipped off carefully even if it is still
cabled.
CageClamp
technology (green)
1
2
3
Locking (orange) for screwdriver
Round opening for wires
Test point for 2mm test tip