Installing and Configuring Tiebreaker
530-0267-00 Rev 02
7700 Flash Storage Platform Installation Guide 7.6.3.x
161
5.
Type
S
and click
Enter
to save the configuration.
Resume Tiebreaker Monitoring
In the event that Tiebreaker stops monitoring a failover pair, follow the steps below to resume
monitoring:
1.
Run command
tiebreakersetup
.
2.
Select
[M]
to modify a failover pair.
3.
Select the failover pair that you want to resume monitoring.
4.
Select
[n]
to start monitoring the failover pair.
5.
Type
Y
to start monitoring failover pair
6.
Type
S
to save the configuration.
Sample Traps Sent by Tiebreaker
The following are examples of traps sent by the Tiebreaker server.
You may receive two SNMP traps (listed below) during the failover configuration removal process,
depending upon how long the removal process takes to complete (you can ignore the first trap).
•
Tiebreaker stopped monitoring because its configuration did not match that of the failover pair.
Update the configuration appropriately and run
setup
to restart Tiebreaker monitoring.
•
Tiebreaker stopped monitoring because the failover configuration was removed. If you
configure failover again, run
setup
to restart Tiebreaker monitoring.
