Vilter VSM 71-701, Operation And Service Manual

Page: 72 / 244

72
Service
1.07 GATE ROTOR ROLLER
BEARING REMOVAL
A) Refer to section 1.01 for removal of the gate
rotor bearing housings and gate rotor sup-
ports.
B) Remove the snap ring (131), which retains
the roller bearing in the bearing housing.
C) Remove the roller bearing (125) from the
bearing housing (112).
D) Use a bearing puller to remove the roller
bearing race (125) from the gate rotor sup-
port (110).
1.02 GATE ROTOR ROLLER
BEARING INSTALLATION
A) Match up the part numbers on the inner race
to the part numbers outer race. Press the bear-
ing race (numbers visable) onto the gate ro-
tor support.
B) Install the outer bearing into the bearing
housing so the numbers match the numbers
on the inner race. Install the snap ring re-
tainer in the housing. The bevel on the snap
ring must face away from the roller bearing.
C) For installation of the bearing housing, re-
fer to section 1.02.
VSM Only