instructions for
HYDRAULIC COIL SpRIng COmpReSSOR
model no:
VS7011.V3
Thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFeTY
WARnIng!
Wear approved safety eye protection (standard spectacles are not adequate).
WARnIng!
Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this equipment.
8
DO nOT
allow untrained persons to use the spring compressor.
8
DO nOT
operate the spring compressor when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO nOT
use the spring compressor for a task it is not designed to perform.
8
DO nOT
operate spring compressor if parts are damaged or missing as this may cause failure and/or personal injury.
9
maintain the
spring compressor in good condition. replace or repair damaged parts.
Use genuine parts only. Unauthorised parts may be
dangerous and will invalidate the warranty.
9
remove ill fitting clothes. remove ties, watches, rings, other loose jewellery. contain and/or tie back long hair.
9
familiarise yourself with the applications, limitations and potential hazards of the spring compressor.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
Keep hands and body clear of the spring when operating the spring compressor.
9
maintain correct balance and footing. ensure the floor is not slippery and wear non-slip shoes.
9
Keep the spring compressor clean for best and safest performance.
9
When not in use release pressure from the spring compressor.
9
Wear appropriate protective clothing.
9
When not in use clean and store the spring compressor in a safe, dry, childproof location.
9
ensure that the locking ring is installed and is firmly secured against the lower.
2. InTRODUCTIOn
the Vs7011.V3 is supplied with a 1 ton hydraulic hand pump unit that powers the ram and yoke assembly. up to 50% quicker than using other
ratchet driven spring compressors. equipped with 2 pairs of spring yokes with plasticised covers to prevent slippage and damage to springs.
3. SpeCIFICATIOn
model no: ........................................VS7011.V3
capacity:..................................................1000kg
maximum working length:..................... 240mm
ram travel:.............................................. 240mm
Weight:..................................................... 19.5kg
small jaw capacity: ........max spring od 122mm
small jaw capacity: ............min spring id 80mm
Big jaw capacity:............max spring od 165mm
Big jaw capacity: .............min spring id 110mm
4. ASSembLY
4.1.
Connect the hose to the ram unit as shown in fig.1. Ensure the hose connectors are
fully seated but
DO nOT
over tighten. see fig.1 for valve operation.
4.2.
ensure the jaws are fully screwed down.
4.3.
Screw locking ring (fig.2) against the bottom jaw to prevent jaw rotating.
Vs7011.V3| issue 4 06/02/17
Original Language Version
© Jack sealey limited
refer to
instruction
manual
Wear eye
protection
Wear protective
gloves
slacken in use to allow cylinder to
breathe. tighten to seal for transit.
fig.1
