Villa Rotograph EVO, Service Manual

Page: 53 / 223

SERVICE MANUAL
Pre-installation
Rotograph EVO (Rev. 1) 5-2
5.1. Electrical setting up
•
Single-phase grounding supply 220-240 V ~
110-120 V ~
• Frequency 50/60 Hz
• Power consumption 1.6 kVA (at 230 V)
1.7 kVA (at 115 V)
• Current consumption 7 A (at 230 V)
15 A (at 115 V)
• Apparent line resistance 0.5 Ω max (for 220-240 V version)
• Line voltage regulation < 3 % at 99 V ~
(for 110-120 V version)
NOTE:
The device is supplied as unit to be installed permanently.
Please DO NOT connect the unit to the line using a normal socket, to
avoid compromising the electrical safety.
The unit must be connected to a differential magneto-thermal
switch, to separate the unit from the supply. This switch must
comply the electrical regulations in force in the country of
installation.
The supply conductors must have a 1,5 mm
2
(16 AWG) section.
The general grounding must comply with the rules in force; a wrong
quality of the grounding could be dangerous for the operator’s safety and
cause a bad function of the electrical devices.
NOTE:
The electrical connection must be done on the terminal board X0 (see
operation circuit diagram – chapter 9).
*
*