Villa Rotograph EVO, Service Manual

Page: 220 / 223

SERVICE MANUAL
Appendix
(Rev. 1) Rotograph EVO A-1
11. APPENDIX
11.1. Appendix A: Setup parameters table
The following table lists those adjustment parameters stored in the unit
during factory testing and that must be re-entered into the non-volatile
memory in case of replacement of the CPU board (A5). This is due to the
fact that the new CPU board, provided as a spare part, has been factory
tested from the functional point of view, but contains only default
parameters which are not related to the unit where it will be installed.
Entering of the listed parameters can be performed through the service
programs (passwords).
NOTE:
The information listed in the table are the technical parameters set
during factory testing. Preferences set by the user (e.g. exposure
parameters different than the default ones) are not listed.
The table also has columns with blank cells. These cells must be filled in
when, during installation or during the life on the unit, any of the listed
parameters will be modified (e.g. after replacing a motor or a positioning
sensor).
*