Vidikron VDP-720, Owner'S Operating Manual

Page: 23 / 56

Vidikron VDP-80-720 Owner’s Operating Manual 13
PRE
L
IMINAR
Y
3.1
Remote Control To install batteries in the remote control:
1. Remove the battery cover from the remote control.
2. Insert the two (3), AA-size batteries included with the remote control. Ensure that the
polarities correctly match the
and markings inside the battery compartment.
3. Replace the battery cover. After a few seconds, the remote starts up automatically and
an Introduction screen appears (see Figure 2-2). The remote control beeps twice to
indicate that it has started up successfully.
Notes on Batteries • When installing batteries, make sure that the battery polarities are correct.
• Do not mix an old battery with a new one or different types of batteries.
• If you will not use the remote control for a long time, remove the batteries to avoid
damage from battery leakage.
Notes on Remote Control
Operation • Do not drop the remote control or expose it to moisture or high temperature.
• The remote control may malfunction under a fluorescent lamp. If that occurs, move the
VDP-80-720 away from the fluorescent lamp.
• Make sure that there is nothing obstructing the infrared beam between the remote
control and the IR receiver on the VDP-80-720.
• If the effective range of the remote control decreases, or it stops working, replace the
batteries with new ones.
• Ambient conditions may possibly impede the operation of the remote control. If this
happens, point the remote control at the VDP-80-720 and repeat the operation.
3
Installation
The signal from the remote control can be reflected by walls or other
surfaces.
Note