POWER REQUIREMENTS
DANGER
• ONLY QUALIFIED
ELECTRICIANS SHOULD
CONNECT INCOMING
POWER TO THE TOOL.
• To reduce the risk of electric shock,
check the electrical source for proper
grounding.
• Always turn off the main power supply
to the tool before making any tool
adjustments or before performing any
maintenance. Follow all lock out tag out
procedures.
• DO NOT alter the plug in any way.
Failure to follow these instructions could
result in death or serious personal injury.
The VE268 Roll Grooving Tool is designed
to operate on several different electrical
configurations. There is a 230/460-volt,
3-phase, 60-Hz version and a 380/400/415-
volt, 3-phase, 50-Hz version. Please ensure
that the power requirement is specified with
the accompanying part code on your order.
If the need arises, a 230-volt tool can be
converted to operate on 460-volt, and vice-
versa. For the 50-Hz version, a 380-volt tool
can be converted to operate on 400-volt or
415-volt, and vice-versa.
To convert a tool between voltages, the
following changes must be completed:
1.
Motor Wiring Configuration
2.
Motor Overload Setting
To convert the tool, refer to the electric
schematic(s) in the RP-VE268 Repair Parts
List and the information listed on the tool’s
drive motor.
All VE268 components are grounded to the
frame of the tool. Ensure that the frame is
grounded properly.
POWER HOOKUP
Each VE268 Roll Grooving Tool is provided with
a label that identifies power specifications for
the tool (see example below). Reference must
be made to this label to ensure proper tool
setup.
VOLTS
PHASE
HERTZ
FULL-LOAD CURRENT
SERIAL NO.
DATE MFD.
230
3
11.5 AMPS
60
• GEAR OIL – AGMA 7
• HYDRAULIC OIL – HIGH-PRESSURE, ANTI-WEAR ISO GRADE 32
• BEARING LUBE – ANTI-WEAR, EXTREME PRESSURE NLGI GRADE 2
VOLTS
PHASE
HERTZ
FULL-LOAD CURRENT
230
3
8.8 AMPS
60
DRIVE MOTOR:
SHORT CIRCUIT INTERRUPTING CAPACITY 5,000 AMPS
Victaulic Company World Headquarters
4901 Kesslersville Road • Easton, PA 18040
Manufactured in
Canada
victaulic.com
11921 Rev. C R511921LBL
ELECTRICAL
ASSEMBLY DWG.
R-301-268-SCH
REVISION LEVEL
VE268
460
3
6.5 AMPS
60
460
3
4.4 AMPS
60
The tool is supplied with a #12/4 power cord
(three power, one ground). After the power
is connected properly, the tool must be
checked for proper rotational direction (refer
to “Verification Of Pipe Rotation Direction” on
page 10).
TM-VE268_7
REV_H
TM-VE268
/ Operating and Maintenance Instructions Manual
Summary of Contents for VE268
Page 2: ......
