5.
Thread the aluminum travel stop knob into
the
3/8
– 16 UNC tapped hole located on
the face of the slide.
6a.
Prepare to support the pipe. Turn the
selector switch on the side of the tool to
the “NORMAL” position. The arm/upper roll
assembly will return to its highest position,
and the pipe will release.
6b.
Turn the power switch on the side of the
tool to the “OFF” position.
MAINTENANCE
DANGER
• Always turn off the
main power supply to
the tool before making
any tool adjustments or
before performing any
maintenance.
Failure to follow this instruction could result
in death or serious personal injury.
This section provides information about keeping
tools in proper operating condition and guidance
for making repairs when it becomes necessary.
Preventive maintenance during operation will
pay for itself in repair and operating savings.
Replacement parts must be ordered from
Victaulic to ensure proper and safe operation of
the tool.
LUBRICATION
After every 8 hours of operation, lubricate the
tool. Always lubricate the upper roll bearings
when rolls are changed.
1.
Grease the upper roll bearings every time
roll changes are made and after every
8 hours of operation. A grease fitting is
provided, as shown above. Refer to the
applicable “Recommended Lubricants”
table for the proper grease.
TM-VE268_38
REV_H
TM-VE268
/ Operating and Maintenance Instructions Manual
Summary of Contents for VE268
Page 2: ......
