LOWER ROLL REMOVAL FOR 2-INCH/
60.3-MM AND LARGER SIZES
WARNING
• Always turn off the main power supply to
the tool before changing the rolls.
Failure to follow this instruction could result
in serious personal injury.
1.
Turn the power switch on the side of the
tool to the “OFF” position.
2.
Using a wrench, loosen the large nut on
the arbor, and back it off ¼ inch/6 mm.
DO NOT remove the large nut.
WARNING
• Use only the aluminum
wedge with a soft-faced
hammer for removing the
lower roll. Never strike the
lower roll directly for any
reason.
• Always wear eye protection
when using the aluminum
wedge.
Failure to follow these instructions could
result in serious personal injury.
3.
To loosen the lower roll from the tapered
arbor, use the aluminum wedge supplied
with the tool. Place the wedge behind the
lower roll, and strike the wedge with a soft-
faced hammer to break the lower roll loose
from the taper. DO NOT strike the lower roll
directly with a hammer.
4.
Remove the nut, washer, and lower
roll. Store these components in the tool
cabinet.
TM-VE268_32
REV_H
TM-VE268
/ Operating and Maintenance Instructions Manual
Summary of Contents for VE268
Page 2: ......
