Vertiv Liebert NXL 1100, Installation Manual

Page: 37 / 73

Installation Drawings
Vertiv
Large System, 3-Phase UPS Battery System Installation Manual 30
Figure 27 Front-terminal battery cabinet shipping split
Install supplied washer
, lockwasher
and bolt to secure units together front and rear
.
Note: Jar 28 must be moved forward or removed to install rear hardware. Rear cutouts are provided if rear access is provided.
Install supplied washer
, lockwasher
and bolt to secure units together front and rear
.
Note: Jar 16 must be moved forward or removed to install rear hardware. Rear cutouts are provided if rear access is provided.
Install snap bushing in corner post before routing these wires
Install snap bushing in corner post before routing these wires
Install snap bushing in corner post before routing these wires
Route two supplied wires (W17) from Jar 15 (+) to Jar 16 (-) Note: Install bushing first.
Route two supplied wires (W16) from Jar 1 (-) to BCB breaker in (-) Note: Install bushings first.
T
ywrap here to
secure wires in place
Use supplied hardware on bus
Use supplied hardware on bus
Remove hardware used to secure lugs in place and discard Connect lugs to bus directly above insulator and secure with supplied hardware on bus.
T
ypically
eight places.
Cabinet A
Cabinet B
Remove these busbars and keep the hardware to secure busbars between Cabinet
A
and Cabinet B
Negative (-)
Positive (+)
Busbars shown connected between Cabinet
A
and Cabinet B
(busbar quantity varies)
Reuse supplied hardware
Jar 16
Jar 28
A
B
T
ywrap here
to secure wires in place
T
ywrap here to
secure wires in place
T
op V
iew
Front
Detail A
Detail B
Isometric V
iew