VEMAG 160.0215, Operating Instructions Manual, Page: 43 / 182

ROBOT HP7E / HP10E / HP12E / HP15E / HP20E 5. Operation
5-1 © VEMAG 2010
5. Operation
5.1 Working with the machine
To start production with the machine, proceed as follows:
• Set up the machine for the product to be filled.
Section 4
• Switch on the main switch of the machine.
• Press the ON switch on the machine control panel.
Danger!
You must check that any safety devices are working properly.
• Unlock the hopper and tip it open.
• Remove the filling horn holder.
In each of the cases described, the machine must switch off automati-
cally. If the machine does not switch off, work may not continue with the
machine. In this case, inform VEMAG Customer Service immediately.
• Pull on a casing suitable for the product to be filled.
• Push the trolley containing product into the trolley hoist of the lifting/
tipping device (optional) up to the stop. The locking lever must lock
and hold the trolley securely in the trolley hoist.
• Press the UP key of the lifting/tipping device to move the trolley over
the hopper with the trolley hoist. The trolley is automatically emptied
into the hopper.
Danger!
Make sure that there is no-one in the area of the lifting/tipping device
during operation and that no objects have been deposited there.
Insert only undamaged trolleys that will be securely held by the trolley
hoist.
• Press the DOWN key to lower the trolley again. The trolley hoist stays
approx. 500 mm above the floor. Press the DOWN key again and
keep it depressed until the trolley has reached the floor.