VEMAG 160.0215, Operating Instructions Manual, Page: 125 / 182

ROBOT HP7E / HP10E / HP12E / HP15E / HP20E 7. Cleaning
7-13 © VEMAG 2010
7.4.3 Chlorine-containing alkaline cleaning agents
Perform cleaning as follows:
• Initial rinse with water to remove coarse dirt
• Application of foam to the surfaces for cleaning using a 2 – 5 % soluti-
on of P3-topax 66 (alkaline) or 2 – 3 % solution of P3-topax 56 (acid).
Time required to take effect: 10 to 20 minutes
• Intermediate rinse with water at 40 – 60 ˚C
• Disinfect if desired and/or required. Time required to take effect: 10 to
30 minutes
• Rinse off with water at 40 – 60 ˚C
Warning!
No residues of the activated chlorine product should be left on surfaces.
Inadequate rinsing may cause metal to corrode or plastics to display
symptoms of degradation. This applies even to materials which are consi-
dered corrosion-resistant.
Recommended cleaning agents:
Alkaline cleaning agent with
chlorine
Acid cleaning agent Disinfectant
P3-topax 66 P3-topax 56 P3-topax 91 (30 min)
P3-topax 52 P3-topactive DES (15 min)
P3-topax 686 P3-topactive 500 P3-topax 99 (30 min)
Topmaxx 314
1)
Topmaxx 520
1)
P3-steril
(manual application, chlorine-
free)
P3-alcodes (in concentrate form with no rinsing off)
1)
Long-cling technology: foam adheres to vertical surfaces for 30 to 60 minutes
In the case of special cleaning requirements and to optimize the cleaning
process, please contact your local ECOLAB consultant.
Europe: +49 211- 9893 203
USA: +1 800 392 3392
+1 651 225 3093 (fax)