Marquee ACON Ultra Installation/Operation Guide
1-6
ACON Ultra Camera/Server Installation Instructions
Figure 1-4. Front Lower Trim Cover Removal.
1.3.2.2
Mounting the Camera Assembly on the Top Bracket
Note: See section 1.4.2.1 to set camera ID.
1. Install brackets
a) Pop the top cover off and set it aside.
b) Remove the lens foam.
c) Remove four screws securing the front cover and remove cover (Figure 1-4).
d) From below, install one 8-32 X 5/8” screw through the pem nut located next to the LVPS and
tighten.
e) Install the bracket (round rod) on the 8-32 X 5/8” screw and tighten (Figure 1-5).
f) Position the front cover and install four screws to secure (Figure 1-4).
g) Remove the center two ¼-20 bolts from the top cross bar over the green CRT and discard (Figure
1-5).
h) Position the spacer with the long end to the left (as you face the projector) and align two holes with
the two holes in the cross bar.
i)
Position the bracket on top of the spacer and align the bracket holes with the spacer holes.
j)
Install two ¼-20X1 ¾” screws with washers through the bracket and spacer and into the cross bar.
Do not tighten.
k) Install an 8-32 X 5/8” screw with washer through the bracket and into the (round rod) bracket.
Tighten to secure.
l)
Tighten two screws installed in Step j. to secure.
m) Reinsert the foam piece around the lenses.
R
E
M
O
V
E
LO
WE
R
T
R
I
M
C
O
V
E
R
D
I
S
C
O
N
N
E
C
T
D
B
C
O
NN
E
C
T
O
R
F
R
O
M
L
O
WE
R
T
R
I
M
C
O
V
E
R
RE
M
O
V
E
L
O
WE
R
CO
V
E
R
S
C
R
E
W (4
pla
ce
s
)
INSTALL SCREW (FOR TOP BRACKET
INSTALLATION ONLY)
Summary of Contents for 69871-01
