VCON MediaConnect 9000 Installation & Setup Guide
iii
Safety Information
When you use the MediaConnect 9000 system, observe the following safety
guidelines:
Make sure that the power is turned off and all equipment are disconnected from the
power supply before making all equipment connections.
To help avoid damaging the computer, make sure that the voltage selection switch
on the power supply is set to match the AC power available at your location:
❑
115 V/60 Hz in most of North and South America and some Far Eastern
countries such as Japan, South Korea and Taiwan
❑
230 V/50 Hz in most of Europe, the Middle East and the Far East.
Make sure the monitor and attached accessories (PTZ camera, VCR, document
camera, and so on) are electrically rated to operate with the AC power available in
your location.
To help avoid possible damage to the system cards, wait 5 seconds after turning off
the system before disconnecting a device from the computer.
To help prevent electric shock, plug the computer’s and accessories’ power cables
into properly grounded power sources. These cables are equipped with three-prong
plugs to help ensure proper grounding. Do not use adapter plugs or remove the
grounding prong from a cable. If you must use an extension cable, use a three-wire
cable with properly grounded plugs.
Make sure that nothing rests on the computer system’s cables and that the cables
are not located where they can be stepped on or tripped over.
Do not install this equipment near water, or in an otherwise wet or damp
environment.
DANGER
The internal areas of the computer and auxiliary equipment are
sources of voltage that, if not handled properly, constitute
danger of bodily harm.
DO NOT
operate the computer with any of its covers
(including main cover, bezels, filler brackets, front-panel
inserts, and so on) removed.
DO NOT
tamper with or remove the cover of the computer,
ISDN connection equipment, or any other accessories. Refer
all servicing only to the local VCON distributor or other
VCON-certified technicians.
