Vatech PAX-I, User Manual

Page: 102 / 137

PaX-i (PCH-2500) User Manual
102
8. Troubleshooting
8.
Troubleshooting
If a problem occurs while operating this equipment, perform the corresponding
troubleshooting measure outlined in the table below. If the problem persists,
please contact our customer support staffs.
- If the device is not moving
Cause Solution
Power failure
Check the equipment’s power supply.
Initialization status
Wait until the equipment has initialized and then try
again.
Control PC
connection failure
Check the connection status of Serial Port (RS232)
which connects the PC to the equipment.
- If the exposure switch is not functioning
Cause Solution
Ready status
Check whether it is ready for capturing the imaging
program.
- If imaging cannot be performed
Cause Solution
Initialization status
Wait until the equipment has initialized and then
try again. If this problem persists, restart the
equipment.
- If the laser beam has shut off and patient alignment cannot be
performed
Cause Solution
The time allotted for
patient alignment
has expired
Press the laser beam button to turn on the lasers
and then carry out patient alignment.
WARNING
- Do not allow any liquids in the vicinity of the machine
as moisture may cause extensive damage to this
equipment’s electrical components.
-
- If a severe problem occurs during image acquisition,
press the red emergency stop button to immediately stop
all moving parts and cut off all power to the equipment’s
electrical components. You may then safely release the
patient from the equipment.
Pi_u272_en_20180514.indd 102 2018-05-14 오전 11:03:30