Vari Agatha, Translation Of The Original Instructions, Page: 43 / 68

Agatha
3.5.6 P
ROBLEMS AND SOLUTIONS
Problem Cause Solution
Cutting disc is not
spinning the engine is not running start the engine
wheel drive clutch lever is not pressed press the lever
insufficient belt tightening adjust the tightening pulley
broken belt exchange the belt with a new one
fallen belt mount the belt
other defect Visit the service centre
The cutter does not move the engine is not running start the engine
wheel drive clutch lever is not pressed press the lever
insufficient belt tightening adjust both tightening pulleys
broken belt exchange the belt with a new one
fallen belt mount the belt
other defect visit the service centre
Engine does not start there is no petrol in the tank refuel
petrol feed is closed open petrol feed
the battery is not charged enough charge the battery
disconnected connector on the starter panel wiring bundle connect the connectors
defective switch or wiring bundle replace with new ones / visit the service
centre
other defect visit the service centre
Brake does not work there is no axial clearance in the brake cable, the cable is
tight
adjust the brake
cam is hard to move lubricate
brake lining has deteriorated – impossible to adjust the brake visit the service centre
Impossible to stop the
cutter wheel drive pulley is broken exchange it with a new one
tight cable wire; bended cable lubricate or exchange cable
tightening pulley does not come back lubricate
The engine cannot be
switched off electrical fault wait until the petrol runs out and seek
service
the motor string control link does not control the short-circuit
contact
wait until the petrol runs out and adjust
other defect visit the service centre
Impossible to stop the
cutting disc tightening pulley does not come back lubricate
Control levers do not
come back
tight cable wire; bended cable lubricate or exchange cable
return spring is broken exchange it with a new one
other defect visit the service centre
Other defect visit the service centre
Tab. 10: Problems and solutions
3.5.7 S
TORAGE
Before any longer storage (e.g. at the end of the season) clean any dirt or plant remains from the cutter. Prevent all unauthorised
persons from accessing the cutter. Protect the cutter from wind but do not use airtight protection, which can cause higher corrosion.

Check that the blades are intact and sharpen them (if damaged, exchange them).
We strongly recommend:
–
Mothball the blades on the cutting disc.
–
Remove all dirt and plant remains.
–
Repair damaged places on colour parts.
–
Empty petrol tank and carburettor (for further instructions see engine user manual).
43
R
ev
iz
e
0
7
/2
0
2
1