Vari Lite VL10 BeamWash, User Manual

Page: 26 / 85

12
Installation Procedures
Hanging the Luminaire
The VL10 BeamWash can be hung horizontally or vertically from any structure designed to
work with the type of load created by this moving luminaire. Two mounting truss hooks or
other mounting hardware are required. Many compatible truss hooks are available from
different manufacturers for your particular needs. A minimum of
two hooks per luminaire is required. If mounting method does
not use truss hooks, two attachment points, per luminaire, are
required.
Install mounting hardware and brackets:
Step 1. Install truss hooks on two provided truss hook brackets
as required as shown in Figure 2-2.
Step 2. Determine required configuration of bracket installation.
Brackets may be insta/lled in many different orientations as
shown in Figure 2-3.
Step 3. While pulling up on locking mechanism release, fit
keyed holes onto raised mounting buttons at bottom of enclosure. Slide forward and release
locking mechanism to lock in place. Ensure brackets are locked securely.
WARNING: Ensure that the bracket locking mechanism is fully seated after the bracket is
installed on the luminaire.
AVERTISSEMENT: Assurez-vous que le mécanisme de support de verrouillage est
complètement inséré après le support est installé sur l'appareil.
INSTALLATION : POWER AND DATA CABLING REQUIREMENTS
2
Figure2-2:Truss Hook Installation