Vari Lite VL10 BeamWash, User Manual, Page: 79 / 85

65
Step 5. Remove current gobo by carefully pressing on edges of gobo carrier with fingers,
pressing gobo toward front end of luminaire (toward lens), and out of wheel.
Figure A-3: Replacing Gobos
Step 6. Install new gobo as follows: (Rotating Gobo Wheel are metal gobos, VLFX Wheel
are glass gobos)
a. Place the gobo holder on a clean, flat work surface with the teeth facing
upwards. The gobo is held in place in the gobo holder by a spring. Taking care
to avoid scratching or applying pressure to the gobo, lever the end of the spring
out, remove the spring and then lift the gobo out of the gobo holder.
b. See illustration below. Hold the gobo with the dark side facing upwards towards
the teeth in the gobo holder. Match up the alignment marks (arrowed) in the gobo
and gobo holder. Lay the new gobo flat in the gobo holder.
Figure A-4: Install New Gobo
c. Insert gobo holder into the Rotating Gobo wheel, ensuring that holder snaps into
place.
Step 7. Rotate desired gobo wheel until required gobo position is accessible.
VARI LITE VL10 BeamWash User’s Manual
Do not touch glass with bare fingers.
CAUTION: Press on gobo carrier only.
ROTATING GOBO WHEELS