Vari Lite VL10 BeamWash, User Manual, Page: 30 / 85

16
Addressing
Program Starting Address
The address setting for DMX console controlled systems is entered using the Menu Display
(refer to
“Menu Operation” on page 52 ). The luminaire retains the DMX address even if
power is removed.
Note: Refer to your console operating instructions for specific information regarding its
addressing requirements.
Program a DMX starting address:
Step 1. Power unit on (either via mains or battery)
Step 2. Press to access menu
Step 3. Press or to access ADDRESS and press
Step 4. Use or to move cursor to Hundreds, Tens or Ones...then press or
to select desired digit. Note it will scroll from 9 to 0 or 0 to 9. Once all three digits are set,
press to accept
Program Starting Address Without Calibrating Luminaire
It is possible to bypass the calibration sequence and go directly to the Menu Display
programming in order to pre-program an address setting.
Program starting address without calibrating luminaire:
While powering up luminaire, press and hold . Program address as in Program
Starting Address above.
Press and hold until display changes to the DMX address.
Or boot via battery. Press and at the same time until display boots
Note: The luminaire will require a reset to restore control. See “VL10 BeamWash Control
Channel Functions” chapter on page 28 for control channel information on luminaire reset.
INSTALLATION : POWER AND DATA CABLING REQUIREMENTS
2