15
Powering Up
Power Up and Configuration Procedure
The internal color, gobo, and beam mechanisms will also move through a full range of
motion. After calibration, the luminaire head will either stop at its "home" position (which
positions the pan axis at mid-rotation and the head parallel to the yoke with the lens pointing
away from the luminaire upper enclosure) or move to its current DMX-defined position if
DMX data is present. All internal mechanisms also move to their "home" or DMX-defined
positions.
Subsequently, depending on the luminaire’s setting for Power-Up State (refer to
“VL10
BeamWash Menu System Function Chart” on page 54
).
CAUTION: Before applying power, be sure the luminaire is hung or positioned so that the
head and yoke can move freely without restriction. Make sure service tilt and pan locks are
disengaged so luminaire moves freely.
To power up:
At each luminaire, apply power by connecting luminaire to input power source (100 to
240VAC). Luminaire will automatically step through following procedure:
a. Luminaire will cycle through calibration and stop at "home" position.
VARI
LITE VL10 BeamWash User’s Manual
Summary of Contents for VL10 BeamWash
