Vari Lite VL10 BeamWash, User Manual

Page: 76 / 85

62
Routine Maintenance
Lamp Replacement
WARNING:Ensure that power is removed from luminaire when installing lamp.
WARNING:The light source contained in this luminaire shall only be replaced by the
manufacturer or his service agent or a similar qualified person.
CAUTION: Wear cotton gloves or other covering while installing lamp. Touching lamp
glass with bare fingers will leave oil and may cause the lamp to explode or reduce lamp life.
If touched, use alcohol and cotton cloth to thoroughly clean glass portion of lamp.
To replace lamp:
Step1: Ensure power is removed from luminaire.
Step2: Loosen the screws at A, B & C, and remove the metal panel.
Step3: Gently remove the two mains connected to the lamp.
Step4: Remove the latch by loosening the screw, and swing the lamp retaining clip out.
Step5: Hold the lamp by its ceramic base and remove it carefully.
Step6: Check and clean for debris.
Step7: Hold the new lamp by its ceramic base and install it carefully.
Step8: Slide in the lamp retaining clip, place the latch back and tighten the screw.
Step9: Connect the two mains to the lamp.
Step10: Reinstall the metal panel and fasten the screws at A, B & C.
Step11: Apply power to the fixture.
Step12: Reset lamp hours in the menu.
Figure A-1: Installing Lamp
TROUBLESHOOTING AND MAINTENANCE
A
Allow lamp to cool
CAUTION: before servicing.
Do not touch lamp or
CAUTION: reflector with bare fingers.
Mains
latch