VAMP Ltd
Feeder and motor manager
Operation and configuration
VAMP 257
VM257.EN002
VAMP 24h support phone +358 (0)20 753 3264
39
6.
PC software
6.1.
PC user interface
The PC user interface can be used for:
•
On-site parameterization of the manager
•
Loading manager software from a computer
•
Reading measured values to a computer
Two RS-232 serial ports are available for connecting a local PC;
one on the front panel and one on the rear panel of the
manager with the right operation model (see details in the
technical description). The serial ports are connected in
parallel. However, if the connection cables are connected to
both ports, only the port on the front panel will be active. To
connect a PC to the front panel serial port, use a connection
cable of type VX 003-3.
You can also use the VAMPSET software through a TCP/IP
LAN connection. Optional hardware is required.
6.1.1.
Using VAMPSET program
For more information about the VAMPSET software, please
refer to the user’s manual with the code VMV.EN0xx. If the
VAMPSET user’s manual is not available, please download it
from our web site at www.vamp.fi.
6.2.
Remote control connection
The protection manager communicates with higher-level
systems, e.g. remote control systems, via the serial port
(REMOTE) on the rear panel of the manager.
ModBus, SPABus, IEC 60870-5-103, ProfiBus, ModBus TCP or
DNP 3.0 can be used as REMOTE communication protocols
(see details in the technical description).
Additional operation instructions for various bus types are to
be found in their respective manual.
